top of page

SALE

Mandala Edition
Shop: Stores

Get in Touch

Thanks for submitting!

4.jpg
4.png
Check our Youtube video for instructions on how it works
  • Hold your phone as you normally do and locate the best position for the pop holder. It can be in the center or below, depending on how you hold your phone.

       If you want to apply two pop holders, make sure they align with each other beforehand.

  • Clean the surface of your phone. Peel off the adhesive protector, and apply the pop holder carefully in position

  • Press down on the pop holder and hold it firmly for at least 15 seconds. Leave it to let the adhesive set for a few minutes. You can test the pop holder over a safe surface (like your bed or a sofa) before first use.

If not satisfied with the first application:

No worries! You can still remove the pop holder and replace it. A plastic card (credit card) can be used to gently but firmly lift the adhesive upward at an angle until it fully pulls off. Do not rip it off, simply keep lifting, the adhesive will slowly detach itself out. You can now re-apply it by repeating the steps above. If the adhesive gets dirty and cannot stick anymore, you can make the adhesive part sticky again by rinsing it well under cool running water for about 30 seconds. Make sure to gently rub out any dirt, let it dry for 15 minutes and re-apply. Please keep in mind that we cannot guarantee 100% efficiency of this method.

bottom of page